Tech Tips

	01  Analog to Floating Point Conversion
	02  Analog to Pneumatic Conversion
	03  Engineering Conversion Table
	04  Pneumatic Interface Tips
	05  Pneumatic Oscillation Tips
	06  Pulse Width to Pneumatic Conversion
	07  Resistive to Analog Conversion
	08  Splitting and Isolating a Loop Powered 4-20 mA Signal
	09  Splitting a 4-20 mA Signal into Two Outputs
	10  Pulse Width to Resistance Conversion
	11  Pulse Width to Relay (4 or 8)
	12  Boost your Triac Signal, with Relay or Silently with TOB
	13  Closed Loop and Open Loop Explained
	14  Average 4 Signals, or Select Highest/Lowest, or Difference of Two
	15  Staging Signal Output
	16  Signal Isolation, Rescale, and Limit
	17  LonWorks Interfaces (Analog, Pneumatic, and Serial)
	18  Transducer Enclosure
	19  Transducer Filtering
	20  Manual Pneumatic Override (MPO)
	21  Fail-safe Dual Valve (Non-Bleed) Pneumatic Transducers
	22  Low and Line Voltage to Relay Output
	23  Digital On/Off Signal Multiplexor (Powerline Carrier Transmitter)
	24  Accessory Products
	25  DIN Rail Adapter (DRC)
	26  Manual Override Modules (MAO and MDO)
	27  Analog to Relay (Two Handy AAR Applications)
	28  Lighting Control Products Roundup (Pholon and Photon4.1)
	29  Analog, Pulse, Floating Point to Resistance
	30  Analog Signal (How to Send 3 Miles and More)
	31  High Pressure Air to Analog Signal
	32  How to Split and Isolate Any Analog Signal
	33  PSG -A Portable Signal Generator and Troubleshooting Tool
	34  Failsafe Transducers Explained
	35  Pulse Width Modulation Explained
	36  AIM2 Explained (for Analog Isolation)
	37  High Pressure Pneumatic Transducer Lineup
	38  Digital to Analog (using ARM), Binary to Analog (using 4N1 Version 2)
	39  How to Slow Down an Analog Signal Output
	40  Floating Point to Pneumatic Explained
	41  Temperature vs nvoSensor Values for Lonworks Products
	42  Pulse to Analog Conversion + Minimum Output if no Pulse within 60 Seconds
	43  +12/-12 VDC to Analog (Diverified Technologies Replacement) See also "49"
	44  Boost Analog Signal Current Output (using the ARM)
	45 Convert a Negative Signal to a Positive Signal
	46 Pulse Range to Different Pulse Range Converter
	47 Signal Current Booster (ASA). Adds "Beef" to your Analog Output
	48 Split and Rescale an Analog Signal
	49 Convert -12/+12 VDC Pulse to Analog (Diverified Technologies Replacement)
	50 Convert 2 Wire Resistive Signal to Analog